SVAT Electronics WSE100 - Manuel (Page 4)

Please read this manual carefully before using the Wireless Spy Eye. If you
have any difficulties using this unit, please consult the following checklist.
No picture or sound
1. Check and make sure that the power adapters are properly
attached to the units.
2. Make sure that all cables are connected to the proper colours and
are snug with the jacks.
3. Make sure that the camera and the receiver are both on the same
channel
4. Make sure that the proper adapter is connected to each unit.
(12V adapter for the receiver and 8V adapter for the camera.)
Interruption in Image and Sound (audio only on the WSE200)
1. If there is a microwave oven close by, turn the microwave oven off.
2. You may have other units that run on the 2.4GHz signal. Move their
base away from both the camera and/or the receiver.
3. If the picture is fuzzy, adjust the focus of the lens until the picture
becomes more clearer.
4. Your home may have a metal frame that reduces the range of the
unit. Contact SVAT customer service for more information.
Poor Reception Quality
1. Move the receiver around to see it reception improves.
2. Make sure all the A/V cables are plugged firmly and tightly.
3. Make sure the channel selection on the transmitter and receiver
match each other.
Note: Wireless transmissions are not secure and can be intercepted.
w w w . s v a t . c o m