JVC RC-EZ38S - Manuel (Page 11)

7
English
SETTING THE CLOCK
RANDOM
MUTING EQ
1 2 3
4 5 6
7 8
9 0 VOL
REMOTE CONTROL UNIT
TAPE
TUNER/ BAND CD USB
REPEAT
SLEEP
MENU/ FM MODE
STOP/ ENTER
PROGRAM/ PRESET
STANDBY/ ON /
3, 5 2, 4, 6 3, 5 3, 5 1 1
Before operating the unit any further, first set the clock
built in this unit.
There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2 again.
1 Press STANDBY/ON to turn on.
2 Press and hold CLOCK.
The hour digits start flashing.
3 Press 4 or ¢ to adjust the hour.
4 Press CLOCK.
The minute digits start flashing.
5 Press 4 or ¢ to adjust the minutes.
6 Press CLOCK.
Note:
If there is a power failure, the clock loses the setting.
The clock indication will keep flashing until you set the
clock again.
To show the clock when the unit is on
Press CLOCK.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
To set the sleep timer
When the time you specify elapses, the system will be
turned off automatically.
On the remote control only.
1 Press SLEEP.
Flashing “SLEEP 10” and “ S ” are displayed.
00:01 005
S SLEEP 10
Each time you press the SLEEP button, the time length
changes as follows:
10
=20=30=60=90=120=OFF=(back to the
beginning)
2 Wait for a few seconds.
Only the “ S ” is displayed, and the sleep timer is set.
To Confirm the Sleep Time:
Press SLEEP once while the sleep timer is set.
To Cancel the Sleep Timer Setting:
Press SLEEP repeatedly until “SLEEP OFF” appears.
Note:
The sleep timer will also be cancelled when the power is
turned off.
CSH06F134_03_Body_En.p65 2006.6.28, 11:54 AM 7