JVC CA-FSJ60 - Manuel (Page 20)

17
English
Playing Back Tapes
You can play back type I tapes.
Playing Back a Tape
1
Press PUSH OPEN
0 on the unit.
2
Put a cassette in with the exposed part of
the tape down.
3
Press PUSH OPEN
0 again to close the
cassette holder.
4
Press TAPE
2 3.
The unit automatically turns on and the
tape starts playing. The tape direction
indicator (
3 or 2) flashes slowly on the
display.
• Each time you press the button, the tape direction
changes:
3 : plays the front side.
2 : plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is set to
or . (See
“To play both sides—Reverse Mode.”)
If no cassette is inserted when you press TAPE 2 3
“NO TAPE” appears on the display.
To stop playing, press 7.
To fast-wind to the left or to the
right, press
¢ or 4 while the
tape is not running.
The tape direction indicator (
3 or 2)
starts flashing rapidly on the display.
To remove the cassette, press PUSH OPEN 0 on the unit.
• If the tape is playing, stop it first.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE (reverse mode).
• Each time you press the button, the Reverse
Mode changes as follows:
: The deck automatically stops after playing both
sides of the tape. Stops when playback in the 2
direction is finished.
: The deck continues to play both sides of the tape
until 7 is pressed.
: The deck automatically stops after playing one
side of the tape.
• DO NOT open the cassette holder when the tape
is running.
• The use of C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
REV.
MODE
PUSH OPEN
TAPE
EN14-17_FS-J60&50[C]f.pm6 03.1.23, 7:43 PM 17