JVC AV 27320 - Manuel (Page 14)

Connections
75Ω
(VHF/UHF)
INPUT 2
VIDEO/Y
COMPONENT
VIDEO
AUDIO OUT
L
R
R
INPUT 1
S-VIDEO
VIDEO
OVER
R
AUDIO
L/MONO L/MONO PB
PR
WALL
CABLE or ANTENNA
OUT
OR
TWO-WAY
SPLITTER
VCR
IN
OUT
V L R
IN
OUT OUT
1) Connect the antenna or cable TV wire from the wall outlet, in to the RF Input of the two-way
splitter.
2) Connect an RF cable from the one of the RF Outputs on the splitter, in to the RF Input on
the back of the VCR.
3) Connect an RF cable from the other the RF Output on the splitter, in to the RF Input on the
back of the TV.
4) Connect the yellow video cable out from the VCR’s Video Output, in to the TV’s Video Input
jack, OR connect an S-Video cable from the VCR’s S-Video output, to the TV’s S-Video
input.
5) Connect the white audio cable out from the VCR’s Left Audio Output, in to the TV’s Left
Audio Input Jack.
6) Connect the red audio cable out from the VCR’s Right Audio Output, in to the TV’s Right
Audio Input jack.
• If your VCR is a mono sound unit, it will have only one Audio Out jack. Connect it to the TV’s
Left Audio Input.
• Please consult your VCR’s owner’s manual for more information on its operation.
Cable and VCR Connections
14
Illustration of AV-27D303
Diagram #1
There are three basic types of antenna or cable connections:
• If you have an antenna or have a cable system that does not require you use a cable box
to select channels, please refer to Diagram #1.
• If you have a cable system that requires the use of a cable box to access all the channels,
please refer to Diagram #2.
• If you have a cable system that requires the use of a cable box to access certain premium
channels, but not “basic” cable channels, please refer to Diagram #3.
• For your convenience, connection to a VCR is also shown in the following diagrams. A
VCR is not necessary for operation of the television. You may omit the VCR from your
connections if you wish.
• For instructions on connecting a VCR only, please see the Quick Setup on page 12.
FE English 5/13/02 8:52 AM Page 14