Jenn-Air W10394706A - Manuel (Page 14)

14
Complete Installation
1. Refer to the “Make Gas Connection” section for properly
connecting the cooktop to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. LP gas flames have a slightly
yellow tip.
3. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
STRIP CIRCUIT
Griddle 120V Control Wiring Diagram To Cooktop Stand-Alone
R
W OR/W
OR/W OR/W
W
V
W
V V W W
P2-1
P2-6
P1-1
P1-3
P1-4
P1-6
Rotary Control
RTD
BU W
1320W/120V
Lamp 120V