Invacare 6264P - Manuel (Page 4)

Leg Extensions and 4 Part No 1118382
Wheeled Walker Accessories
Installing Rear Leg Extension Options
NOTE: For this procedure, refer to FIGURE 2.
NOTE: Refer to Installation Warning on page 2.
1. Press the snap buttons to remove the two existing rear leg extensions from the walker.
NOTE: The rear leg extensions will not be reassembled to the walker when using the rear wheel
attachments.
2. Press the snap button on the walker frame and install the new wheel attachment/leg
extension onto rear leg of the walker.
3. Repeat STEP 2 for remaining rear leg.
4. Adjust the wheel attachment/leg extension to one of the adjustment holes.
5. Repeat STEP 4 for remaining wheel attachment/leg extension.
6. Ensure that the snap button of each leg fully protrudes through the desired adjustment
hole and legs are adjusted so the walker sits level.
FIGURE 2 Installing Rear Leg Extension Options
Installing the Glide Tip
NOTE: For this procedure, refer to FIGURE 3 on page 5.
NOTE: Refer to Installation Warning on page 2.
1. Press the snap buttons on the walker frame to remove the rear leg extension from the
walker.
2. Firmly grasp the leg extension and perform one of the following:
• Remove the existing glide tip from the leg extension.
• Remove the rubber tip from the leg extension.
Adjustment
Holes
Adjustment
Holes
DETAIL “A” - MODEL NOS.
6264, 6264P, 6265, AND 6265P
DETAIL “B” - MODEL NOS.
6263 AND 6274
Brake
with
Wheel
Sure Glide
Adjustment
Holes
DETAIL “C” - MODEL NO.
6266
NOTE: Brake with wheel is on
same side of adjustment holes
on model nos. 6264 and 6265.