Camera mounting and aiming, Reformatting the micro sd card – MIDLAND XTC100 Manuel d'utilisation

Page 5

Advertising
background image

4

www.midxtc.com

Camera Mounting and Aiming

Mount on Dual Track System

The XTC-100/150 was innovatively designed with an identical dual

track mount system on either side of the camera. This allows you to

mount it on both sides of a helmet with ease. In addition, the main mount

piece is interchangeable and can be moved from the helmet mount to

the goggle mount. This eliminates the hassle of having to remount the

camera every time.

To mount the camera on the main mount piece, slide the camera onto

the dual track system with the two notches on the mount facing towards

the back of the camera.

To detach the camera from the main mount, hold the camera with the

lens facing away from you. Press down the mount release switch and pull

the mount towards yourself.

Dual Track

Mounting System

Mount Release

Switch

Interchangeable

Mount

Aiming the Camera when mounted with the dual track mount:

When mounting the camera on a helmet, you must do the following:

1. Consider what you would like to shoot and mount the camera

accordingly- left side, right side or top.

2. Find a flat surface and ensure the area is clean of dirt and debris.

Remove the cover of the adhesive pad and adhere to the helmet.

3. Once attached, adjust the camera to be sure you are not filming the

sky or the ground.

Mount using the Thread Mount

On the bottom of the XTC-100/150 is a standard thread mount that

allows the camera to be mounted to a tripod or other fixture with a 1/4-

20 (1/4” diameter, 20 threads per inch) 5/16 deep thread. The vented

helmet strap mount is a screw type mount. To affix the camera, insert

the screw on the mount into the camera thread and rotate the camera

clockwise to tighten down onto the screw.

Thread Mount

Screw Mount

Aiming the Camera when mounted with the thread mount:

When mounting the camera on the handlebars of a bike or with the

vented helmet strap mount follow these steps:

1. Consider what you would like to shoot and mount accordingly.

2. Ensure once attached that the camera is aimed straight

and

not

towards the ground or at the sky.

Reformatting the Micro SD card

The Micro SD card can be reformatted while in the camera. This allows you

to delete all the videos at one time. Follow these steps:

1. Move the RECORD switch to the record position.

2. When the battery indicator turns green, press and hold the

Micro SD card reformat button.

3. Keep the Micro SD card reformat button down until the record indicator

turns off and the SD card indicator begins blinking green.

4. Move the RECORD switch to the off position.

Camera Mounting and Aiming

Over tightening may cause damage

to the mount and/or camera

Note: The camera cannot reformat the Micro SD card if the low

battery light is on.

Ensure

batteries are new or fully charged before formatting

Advertising
Ce manuel est liée aux produits suivants: