Marvel Group 6GARM - Manuel (Page 4)

INSTALLING YOUR BEVERAGE COOLER
Select Location
The proper location will ensure peak performance of your ap-
pliance. We recommend a location where the unit will be out
of direct sunlight and away from heat sources. To assure your
product performs to specifications the recommended installation
location temperature range is from 65 to 80°F (18 to 27°C) for
indoor built in units, 65 to 90°F (18 to 32°C) for indoor freestand-
ing units.
Cabinet Clearance
Ventilation is required from the bottom front section of the unit.
Keep this area open and clear of any obstructions. Adjacent
cabinets and counter top can be installed around the unit as long
as the grille and door access remain unobstructed.
4
Leveling Legs
Front Toe Grille,
keep this area
open.
Front Grille
Do not obstruct the front grille. The openings within the front
grille allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy usage
and loss of cooling capacity. For this reason it is important this
area to not be obstructed and the grille openings kept clean.
AGA MARVEL does not recommend the use of a custom made
grille as air flow may be restricted because of inadequate open-
ings. (See Figure 2).
Leveling Legs
Adjustable legs at the front and rear corners of the unit should
be set so the unit is firmly positioned on the floor and level
from side to side and front to back. The overall height of your
Marvel refrigerator may be adjusted from 33-7/8” (86.1cm) with
the leveling legs turned in, and up to 34-3/4” (88.3cm) with the
leveling legs extended.
To adjust the leveling legs, place the refrigerator on a solid
surface and protect the floor beneath the legs to avoid scratch-
ing the floor. With the assistance of another person, lean the
refrigerator back to access the front leveling legs. Raise or lower
the legs to the required dimension by turning the legs. Repeat
this process for the rear by tilting the refrigerator forward using
caution. On a level surface check the refrigerator for levelness
and adjust accordingly.
The front grille (toe grille) screws may be loosened and the grille
adjusted to the desired height. When adjustment is complete
tighten the two toe grille screws. (See Figure 4).
Rear leveling legs
Figure 3
Figure 2