Assembly – Murray 96017000500 Manuel d'utilisation

Page 7

Advertising
background image

7

ASSEMBLY

FIG. 2

NOTE: You may now roll or drive your tractor off the skid.

Follow the ap pro pri ate instruction below to remove the

tractor from the skid.

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be

sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID (See Op-

er a tion section for location and function of

con trols)

• Press lift lever plunger and raise at tach ment lift lever

to its highest po si tion.

• Release parking brake by depressing clutch/brake

ped al.

• Place gearshift lever in neutral (N) po si tion.
• Roll tractor forward off skid.

Remove banding holding the de flec tor shield up against

tractor.

TO DRIVE TRACTOR OFF SKID (See Op-

er a tion section for location and func tion of

con trols)

Be sure all the above assembly steps have been com-

plet ed.

• Check engine oil level and fill fuel tank with gasoline.

Sit on seat in operating position, depress clutch/brake

pedal and set the parking brake.

• Place gear shift lever in neutral (N) position.
• Press lift lever plunger and raise at tach ment lift lever

to its highest position.

• Remove key from bag and start the engine (see "TO

START ENGINE" in the Operation section of this man-

ual). After engine has started, move throttle control to

idle (slow) position.

Depress clutch/brake pedal into full "BRAKE" position

and hold. Move gearshift lever to 1st gear.

• Slowly release clutch/brake pedal and slowly drive

tractor off skid.

Apply brake to stop tractor, set parking brake and place

gearshift lever in neutral position.

• Turn ignition key to "STOP" position.
Continue with the instructions that follow.

FIG. 3

CHECK BATTERY (See Fig. 3)

• Lift seat pan to raised position.
• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in MAINTENANCE section of this

manual for charging instructions).

SEAT PAN

LABEL

TERMINAL

TERMINAL

ADJUSTMENT

KNOB

24

66

02464

SEAT PAN

SHOULDER

BOLT

FLAT WASHER

SEAT

Advertising