Maytag Bravos W10201175A - Manuel (Page 21)

21
2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner
dryer back panel. Push down on front edge of drying rack to secure at the front of the
dryer.
A
B
A. Dryer rack front edge
B. Dryer back panel
3. Put the wet items on top of the drying rack. Leave space between the items so air can
reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying rack.
4. Close the door.
5. Press the POWER/CANCEL button.
6. Select a Timed Dry cycle and temperature (see following chart). Items containing foam,
rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
7. You must select a time by pressing TIME ADJUST + (plus) or – (minus) . Reset time as
needed to complete drying. Refer to the following table.
8. Press START/PAUSE.
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting, and drying time. Actual drying time will depend on the amount of
moisture items hold.
Rack Dry Setting Temp. Time*
(minutes)
Wool Sweaters
Block to shape and lay flat on the drying rack. Timed Dry Low 60
Stuffed toys or pillows
Cotton or polyester fiber filled Timed Dry Low 60
Stuffed toys or pillows
Foam rubber filled Timed Dry Air Fluff
(no heat)
90
Sneakers or canvas shoes Timed Dry Air Fluff
(no heat)
90
*Reset time to complete drying, if needed.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Cleaning the Lint Screen
Clean the lint screen before each load. The control panel has an indicator light to remind you
to clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Rack Dry Setting Temp. Time*
(minutes)