Metrologic Instruments ScanQuest IS4110 - Manuel (Page 13)

9
D
EFAULT
S
ETTINGS
Many functions of the IS4125 decode scan engine can be configured or
enabled/disabled. The decode engine is shipped from the factory configured to a
set of default conditions. The default parameter of the decode scan engine has
an asterisk (*) in the charts on the following pages. If an asterisk is not in the
default column then the default setting is OFF or disabled. Every interface does
not support every parameter. If the interface supports a parameter, a check
mark ( ) will appear in interface column.
Parameter Default
RS232
OR
RS232
TTL
Light
Pen
Keyboard
Wedge
USB
Enter Configuration Mode, After Any Scan *
Enter Configuration Mode, Only on First
Scan
Short Range Activation
Long Range Activation
*
Normal Scan
*
Pulsing Scan
Custom Scan
DTR Activation
DC2 Activation
Address Based Activation
“NOREAD” message Transmission
Turn on Green LED during “NOREAD”
Transmit
*
Short Same Symbol Re-scan
Long Same Symbol Re-scan
*
Green LED Identical Symbol
Re-Scan Indicator
1 Vs 2 Scan Buffers 1
2X Redundancy (MECCA
Double Border Requirement
(Large Intercharacter Space Requirement)
Alternate Beeper Tone 1
Alternate Beeper Tone 2
*
Alternate Beeper Tone 3
No Beeper tone
Two Second Timeout