Memorex MPH7825 - Manuel (Page 7)

6
4
5
7
6
8
Rear View
1 2
3
Bottom View
(Figure 2)
BASE UNIT CONTROLS
1.
9VDC Adapter Jack: A jack located on the rear side of the base unit used for connect-
ing the adapter to the base unit.
2. TEL LINE JACK: Accepts line cord to make connection with modular type telephone
outlet.
3. T / P (Tone / Pulse) Switch: Allows you to switch the dialing mode to either Tone or
Pulse dialing.
4. Charge Terminals: Used for charging handset battery. We recommend that you clean
these contacts periodically with an alcohol-moistened cloth or cotton swab.
5. PAGE Button: Allows you to locate the handset when it is not on the base unit.
6. CHARGE LED Indicator: Turns on when the base is charging the handset. Turns off
when the handset is removed from its cradle
7. IN USE LED Indicator: Lights up steadily when the phone is being used. Flashes
when an incoming call is received and during paging condition.
8. Retainer Tab: Allows the handset to hang from the base unit when the base unit is
placed in the wall mount position.
MOUNTING POSITION
DESKTOP USE:
Connect the telephone line cord to the TEL LINE jack
on the rear of the base unit and connect the opposite
end to the telephone modular jack.
WALL USE:
A. WITH A STANDARD MODULAR WALL JACK
1.
Install the wall mount bracket at the position as shown in Figure 4.
2. Connect the short telephone line cord to the TEL LINE jack on rear of the base unit.
3. Connect the opposite end of the telephone line cord to the modular wall jack.
4. Align the wall mounting slots with the studs located on the modular wall plate and slide
the base down to lock in place.
(Figure 3)