Maytag W10260034A - Manuel (Page 8)

8
Changing Cycles, Options, and Modifiers
You can change Sensor Dry Cycles, Timed Dry Cycles, Options, and
Modifiers, anytime before pressing START.
NOTE: Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after pressing START
1. Press PAUSE/CANCEL twice. This ends the current cycle.
2. Select the desired cycle and options.
3. Press and hold START. The dryer starts at the beginning of the
new cycle.
NOTE: If you do not press START within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Options and Modifiers after pressing Start
You can change an Option or Modifier anytime before the selected
feature begins.
1. Press PAUSE/CANCEL once.
2. Select the new feature.
3. Press and hold START to continue the cycle.
NOTE: If you happen to press PAUSE/CANCEL twice, the program
clears and your dryer shuts down. Restart the selection process.
Drying Rack Option
Use the drying rack to dry items such as sweaters and pillows
without tumbling. The drum turns, but the rack does not move.
If your model does not have a drying rack, you may be able to
purchase one for your model. To find out whether your model allows
drying rack usage and for information on ordering, please refer to the
front page of the manual or contact the dealer from whom you
purchased your dryer.
NOTE: The drying rack must be removed for normal tumbling. Do
not use Sensor Dry cycles with the drying rack.
To use the drying rack
Do not remove the lint screen.
1. Open dryer door.
A
A. Front edge
2. Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on front
edge of drying rack to secure over the lint screen.
A
B
A. Drying rack front edge
B. Dryer back panel
3. Put the wet items on top of the drying rack. Leave space between
the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying rack.
4. Close the door.
5. Press the POWER button.
6. Select a Timed Dry Cycle and temperature (see following chart).
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using the Air Fluff temperature setting.
7. You may change the cycle time by pressing Timed Dry Cycle
Adjust Up or Down arrow buttons. Reset time as needed to
complete drying. Refer to the following table.
8. Press and hold START button (about 3 seconds).
NOTE: Check the lint screen and remove any lint accumulated from
items dried on the drying rack.
This chart shows examples of items that can be rack dried and the
suggested cycle, temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.
Rack Dry Setting Temp. Time*
(Minutes)
Wool Sweaters
Block to shape and lay flat
on the drying rack.
Timed
Dry Cycle
Low 60
Stuffed toys or pillows
Cotton or polyester fiber
filled
Timed
Dry Cycle
Low 60
Stuffed toys or pillows
Foam rubber filled Timed
Dry Cycle
Air Fluff
(no heat)
90
Sneakers or canvas shoes Timed
Dry Cycle
Air Fluff
(no heat)
90
*Reset time to complete drying, if needed.
NOTE: You must remove drying rack for normal tumbling. Do not
use Sensor cycles with the drying rack.