NEC MultiSync LCD1700V - Manuel (Page 13)

MultiSync LCD1700V 13
INSTALLATION
To install the monitor to your host system, please follow the steps as given below:
Steps
1. Open the connector cover first.
2. And then open the cable cover.
3. Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the video cable to the computer first, then to the monitor.
4. Connect power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
5. Assemble the cable cover.
6. Cover the connector cover.
7. Power-ON Monitor and Computer
Power-ON the monitor first, then power-ON the computer.
This sequence is very important.
8. If the monitor still does not function properly, please refer to the trobleshooting section
to diagnose the problem.
Connector Cover
Cable Cover
(This semi-circle opening is the Cables outlet)
PULL
9
LCD1700V-E.PM6 01.9.19, 6:03 PM 13