GE JGP328 - Manuel (Page 9)

Care and cleaning of the cooktop.
www.GEAppliances.com
Be sure electrical power is off and all surfaces are cool before cleaning any part of the cooktop.
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do
not use any sharp items to remove the
film. Remove all of the film before using
the appliance for the first time. To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive left from packaging tape on
new appliances is an application of a
household liquid dishwashing detergent.
Apply with a soft cloth and allow to soak.
NOTE: The adhesive must be removed from
all parts before using the cooktop. It cannot be
removed if it is baked on.
Control Knobs
The control knobs may be removed for
easier cleaning.
Make sure the knobs are in the OFF positions and
pull them straight off the stems for cleaning.
The knobs can be cleaned in a dishwasher
or they may also be washed with soap and
water. Make sure the insides of the knobs
are dry before replacing.
Replace the knobs in the OFF position
to ensure proper placement.
Pull the knob straight up off the stem.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Porcelain Enamel Cooktop (on some models)
The porcelain enamel finish is sturdy but
breakable if misused. This finish is acid-
resistant. However, any acidic foods
spilled (such as fruit juices, tomato or
vinegar) should not be permitted to
remain on the finish. If acids spill on the cooktop while it is hot, use a
dry paper towel or cloth to wipe it up right away.
When the surface has cooled, wash with an all-
purpose cleaner and water. Rinse well.
For other spills such as fat spatterings,
wash with soap and water or an all-purpose
cleaner after the surface has cooled. Rinse
well. Polish with a dry cloth.
Do not use steel-wool pads or abrasive
cleaners; they will scratch the surface.
Shake CERAMA BRYTE ® bottle well.
Place a small amount of CERAMA
BRYTE
® Stainless Steel Cleaning
Polish and Conditioner on a dry
cloth. Follow the instructions on
the bottle.
Clean a small area (approximately 8
″
x 8
″), rubbing with the grain of the
stainless steel if applicable.
Dry and buff with a clean, dry
soft cloth.
Repeat as necessary.
Stainless Steel Surfaces
(on some models) To order:
To order CERAMA BRYTE
®
Stainless Steel Cleaning Polish
and Conditioner, please call our
toll-free number:
National Parts Center
800.626.2002
www.GEAppliances.com
CERAMA BRYTE
®
Stainless Steel Cleaning
Polish and Conditioner
# PM10X313
9