GE Monogram J2C968 - Manuel (Page 34)

Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Cleaning the glass cooktop.
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Use a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface
and scrape the soil. It will be
necessary to apply pressure to the
razor scraper in order to remove
the residue.
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE ® Ceramic
Cooktop Cleaner* on the entire
burned residue area. Use a
CERAMA BRYTE
® Cleaning Pad
for Ceramic Cooktops* to remove
any remaining residue.
For additional protection,
after all residue has been
removed, polish the entire
surface with CERAMA BRYTE
®
Ceramic Cooktop Cleaner* and a
paper towel.
The CERAMA BRYTE ® Ceramic
Cooktop Scraper* and all
recommended supplies are
available through our Parts Center.
See instructions under “To Order
Parts” section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE ® Ceramic
Cooktop Cleaner* on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE
® Ceramic Cooktop Cleaner.*
This helps protect the top and
makes cleanup easier.
Daily use of CERAMA BRYTE ®
Ceramic Cooktop Cleaner* will
help keep the cooktop looking new.
Remove the burner grates and vent
grille.
Shake the cleaning cream well.
Apply a few drops of CERAMA
BRYTE
® Ceramic Cooktop Cleaner*
directly to the cooktop.
Use a paper towel or CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops* to
clean the entire cooktop surface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Clean your cooktop after
each spill. Use CERAMA
BRYTE
® Ceramic Cooktop
Cleaner.*
Begin by locking the cooktop; see the
Control Lockout section.
Control Lockout
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than the
pad included with your cooktop.
Allow the cooktop to cool.
Remove the burner grates and vent
grille.
Spread a few drops of CERAMA
BRYTE
® Ceramic Cooktop Cleaner*
on the entire burned residue area.
Using a CERAMA BRYTE ®
Cleaning Pad for Ceramic
Cooktops*, rub the residue area,
applying pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE
® Ceramic Cooktop Cleaner*
and a paper towel.
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops.*
34
* For Canadian models, use a Camco-approved equivalent when CERAMA BRYTE ® products are not available.
Contact Camco Replacement Parts to order replacement cleaning products.