GE Monogram ZGU384L - Manuel (Page 12)

Care and Cleaning
Gas Cooktop
12
Dual-flame
spill-proof
burners The burner consists of three parts: the burner
base, burner head and burner cap. The burner
head and burner cap can be lifted off, making
them easy to clean.
CAUTION: DO NOT OPERATE THE BURNER
WITHOUT ALL BURNER PARTS IN PLACE.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
the slots and holes in the burner heads. A sewing
needle or wire twist-tie works well to unclog
these openings.
All slots and holes in the burner head must be
kept clean at all times for proper ignition and
an uneven, unhampered flame.
Cleaning
Lift off burner parts only when cool (see next
page). Wash in hot, soapy water. You may use a
plastic scouring pad to remove burned-on food
particles.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20–30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
After Cleaning
Before replacing the burner parts, shake out
excess water and then dry them thoroughly.
The electrode is located
on one side of each burner.
When one burner is “ON”,
all burners will spark. Do
not attempt to disassemble
or clean around any burner while another
burner is on. An electric shock may result,
which could cause you to knock over hot
cookware. Electrode