GE 48 - Manuel (Page 39)

13 TURN ON THE POWER
• Set the Master Power switch to the I (ON)
position.
• Check to make sure power to refrigerator is on
by opening refrigerator door to see if interior
lights are on.
• The temperature controls are preset at 37°F
for the Fresh Food section and 0°F for the
Freezer section.
• Allow 24 hours to stabilize before making
adjustments.
Raise
Grille
Panel
Water Filter
Master
Power Switch
12 CONNECT WATER SUPPLY
Check to make sure that Master Power switch
is in the O (OFF) position.
• Locate and bring GE SmartConnect ™ tubing
to the front of the cabinet.
• Turn the water on to flush debris from line.
Run about a quart of water through tubing
into a bucket, then shut off water.
Copper Tubing
• Slip a 1/4
″
nut and ferrule onto end
of copper tubing. Insert tube into the union
fitting on the unit and tighten nut to union.
• Turn on the water to check for leaks.
GE SmartConnect ™ Tubing
• Insert the molded end of the tubing
into the refrigerator connection. Tighten
the compression nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks.
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with toekick installation.
Refrigerator
Water Supply
House
Water Supply
Installation Instructions
39