GE Profile 165D4700P382 - Manuel (Page 12)

Caring for the dishwasher.
Cleaning the Control Panel
To clean the control panel, use a lightly
dampened cloth. Then dry thoroughly.
Check the air gap any time your
dishwasher isn’t draining well.
An air gap protects your dishwasher
against water backing up into it if a drain
clogs. The air gap is not a part of the
dishwasher. It is not covered by your
warranty. Not all plumbing codes require
air gaps, so you may not have one. The air gap is easy to clean.
Turn off the dishwasher and lift off the
cover.
Remove the plastic cap and clean with
a toothpick. 2
1
Air gap Does Your Dishwasher Have an Air Gap?
Stainless Steel Interior—Tub and Inner Door
The stainless steel used to make the
dishwasher tub and inner door provides
the highest reliability available in a GE
dishwasher. If the dishwasher tub or inner door should be scratched or dented during
normal use, they will not rust or corrode.
These surface blemishes will not affect
their function or durability.
If your dishwasher is left in an unheated
place during the winter, ask a service
technician to:
Cut off electrical power to the
dishwasher. Remove fuses or trip
circuit breaker.
Turn off the water supply and disconnect
the water inlet line from the water valve.
Drain water from the water inlet line
and water valve. (Use a pan to catch
the water.)
Reconnect the water inlet line to the
water valve. 4
3
2
1
Protect Against Freezing
Operating Instructions
Safety Instructions
Consumer S
uppor
t
Tr
oubleshooting Tips
Before you call for service…
Troubleshooting Tips
Save time and money! Review the charts on the following pages, or visit www.ge.com.
In Canada visit www.geappliances.ca. You may not need to call for service.
Error Messages Possible Causes What To Do
START/RESET status You have pressed the • Press the START/RESET pad once to start the dishwasher. Press the
indicator light flashing START/RESET pad while the START/RESET pad a second time when the dishwasher is running only if you
dishwasher is running. This will wish to cancel the cycle.
cancel the cycle. The light will
stop flashing after the dishwasher
drains (about 90 seconds).
Power to the dishwasher was
• The light will stop flashing after the dishwasher drains. A new cycle will
turned off while a cycle was start automatically.
running and power has just been
restored to the dishwasher. The
blinking lights indicate that the
dishwasher is draining the potential
water inside.
Dishwasher BEEPS This is a reminder that your • Close and latch the door after opening it mid-cycle.
once every 30 seconds dishwasher door has been left
open during operation. It will
continue beeping until you close
the door.
12