Warning, Advertencia, Important – GE 206C1559P197 Manuel d'utilisation

Page 3: Installation preparation, Prepare dishwasher enclosure, Drain requirements, Determine drain method, Cabinet preparation

Advertising
background image

Method 1 – Air Gap with Waste Tee or Disposer
An air gap must be used when required by local codes and ordi-
nances. The air gap must be installed according to manufacturer’s
instructions.

PREPARE DISHWASHER ENCLOSURE

• The rough cabinet opening must be at least 24" deep, 24"

wide and approximately 34-1/2" high from floor to underside
of the countertop.

CLEARANCES: When
installed into a corner,
allow 2" min. clearance
between dishwasher
and adjacent cabinet,
wall or other appliances.
Allow 28-3/8" min. clear-
ance from the front of
the dishwasher for door
opening. Figure B.

DRAIN REQUIREMENTS

• Follow local codes and ordinances.
• Do not exceed 10' distance to drain.

NOTE: Air gap must be used, if waste tee or disposer
connection is less than 18" above floor to prevent siphoning.

DETERMINE DRAIN METHOD

The type of drain installation depends on the following
questions.

Do local codes or ordinances require an air gap?

Is waste tee less than 18" above floor?

If the answer to either question is YES, Method 1 MUST
be used.
• If the answers are NO, either method may be used.

CABINET PREPARATION

• Drill a 1-1/2" diameter hole in the cabinet wall within

the shaded areas shown in Figure A for the drain hose
connection. The hole should be smooth with no sharp edges.

IMPORTANT –

When

connecting drain line to disposer,
check to be sure that drain plug has
been removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT IN PLACE.

Method 2 – “High Drain Loop” with Waste Tee or Disposer

Tip: Avoid unnecessary service call charges.
Always be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.

Figure D

• The dishwasher must be installed so that drain hose is no

more than 10' in length for proper drainage.

• The dishwasher must be fully enclosed on the top, sides and

back, and must not support any part of the enclosure.

24"
Min.

This Wall Area
must be Free
of Pipes or
wires

Plumbing and Electric Service

Must Enter Inside This Area

4"

24"
Min.

6"

5"

5"

4"

Cabinets
Square
and
Plumb

Floor MUST be Even

With Room Floor.

+

34-1/2" 1/4"

Underside of

Countertop

to Floor

32"

Min.

18"

Min.

Drain Hose Hanger

Figure B

Clearance for Door

Opening 2" Minimum

Countertop

Dishwasher

28-3/8"

Figure A

Figure C

Installation Preparation

3

Remove

Drain

Plug

32"

Min.

18"

Min.

Drain Hose Hanger

WARNING:

To reduce the risk of electric shock, fi re, or injury to persons, the
installer must ensure that the dishwasher is completely enclosed
at the time of installation.

ADVERTENCIA:

Para reducir el riesgo de descarga eléctrica, incendio o lesiones a
personas, el instalador debe asegurarse de que el lavaplatos esté
completamente cerrado en el momento de la instalación.

Advertising
Ce manuel est liée aux produits suivants: