GE Monogram 42 - Manuel (Page 23)

23
Type 2 bulb
replacement NOTE: Before replacing the bulbs, review
the light bulb information and WARNING.
Replacing Type 2 bulbs in lamps located in the
top of the Climate Control drawer:
1. Set the Master Light switch to the OFF
position (see Using the Master Light switch)
and allow the lamps to cool.
2. To access the lamps, remove the second
produce pan. See Drawer and Pan Removal
section.
3. The lamps at the back, that face up, can be
lifted out. To access the lamp that shines
into the Climate Control drawer, twist the
holder until the arrow points towards the
back of the refrigerator, then lift up.
4. Turn the lamp
protector to
access the bulb.
NOTE: Always follow bulb manufacturer’s
directions for handling and replacing bulbs.
5. Remove the bulb by holding the base and
pulling straight out. Replace with a new bulb
and replace the lamp protector.
WARNING –
Lamp protectors
must be replaced or the heat from the bulb
could damage the refrigerator.
AVERTISSEMENT :
Vous devez remettre en place les écrans
protecteurs des ampoules pour ne pas
endommager votre réfrigérateur avec la
chaleur produite par les ampoules.
6. Reset the Master Light switch to the ON
position.
Lower lamp
assemblies
Climate Control drawer lamp
Care and Cleaning
Built-In Refrigerators