FUJITSU ST5000 - Manuel (Page 43)

33
C a r e a n d M a i n t e n a n c e
Care and Maintenance
This chapter gives you pointers on how to care for and
maintain your Stylistic ST5000 Series Tablet PC.
CARING FOR YOUR TABLET PC
Please note the following information regarding proper
treatment of your Tablet PC:
■ Your Tablet PC is a durable but sensitive electronic device.
Treat it with respect and care.
■ Make a habit of transporting the system in a suitable car-
rying case.
■ Do not attempt to service the computer yourself. Always
follow installation and operation instructions closely.
■ If you accidentally spill liquid on your Tablet PC:
1. Turn it off.
2. Position it so that the liquid can run out.
3. Let it dry out for 24 hours, or longer if needed.
4. If your Tablet PC will not boot up after it has dried
out, call your support representative.
■ Do not use your Tablet PC in a wet environment (near a
bathtub, swimming pool).
■ Always use the AC adapter and batteries that are
approved for your system.
■ Avoid exposure to sand, dust and other environmental
hazards.
■ Do not expose your Tablet PC to direct sunlight for long
periods of time as excessive temperatures may damage
your system.
■ Do not put heavy or sharp objects on the computer.
■ Do not carry your system in a bag or briefcase while it is
running; doing so could result in overheating or hard disk
drive problems.
■ If you are carrying your system in a briefcase, or any other
carrying case, make sure that there are no objects in the
case pressing on the display.
■ Do not drop your Tablet PC or touch the screen with any
sharp objects.
PROTECTING THE DISPLAY SCREEN
The Stylistic ST5000 Series Tablet PC is designed to
provide you with years of service. Using a screen
protector will help ensure the screen remains as clear as
possible. When installed, the screen protector becomes a
durable, replaceable writing surface that protects the
display screen from abrasion.
To obtain additional screen protectors, use Fujitsu part
number FPCSP08AP (6-pack) when ordering. Additional
information about installation is included with the
screen protectors.
To install a new screen protector on your Tablet PC:
1. If a screen protector is already installed on the display
screen, remove it before installing the new screen
protector.
The screen protector is held onto the display screen
surface by a thin strip of adhesive around the edges. A
notch in one corner of the screen protector allows
you to slide your fingernail under the screen
protector for easy removal.
2. Clean the display by wiping the screen gently using a
soft cotton cloth dampened with isopropyl alcohol.
Ensure that all residue has been removed from the
screen before applying a new screen protector.
Remove the protective coating from the adhesive side
of the screen protector first, as shown in Figure 3-1.
.
Figure 3-1. Removing the Protective Sheet
3. Apply the screen protector to the display screen
surface. When doing so, orient the screen protector
with the adhesive side of the screen protector facing
the display screen and the notched corner of the
screen protector oriented as shown in Figure 3-2.
During normal use of the Tablet PC, small
particles from the environment can become
embedded in the pen tip and scratch the
screen. To prevent scratching the screen,
ensure that a screen protector is installed
before using your Tablet PC. The warranty
does not cover a scratched screen.
■ The Stylistic ST5000 Series Tablet PC is
not waterproof. Do not pour liquids on
the system or wash it with a heavily
soaked cloth.
■ Do not place items on the top of the dis-
play, or damage may occur.
Ocampa3_UG.book Page 33 Monday, August 23, 2004 9:25 AM