FRIGIDAIRE PLHV42P8KC - Manuel (Page 7)

7
Installation Installation Installation Installation Installation
Wiring to Power Supply Wiring to Power Supply Wiring to Power Supply Wiring to Power Supply Wiring to Power Supply
WARNING! WARNING! WARNING! WARNING! WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH
3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREEN
AND YELLOW WIRE MUST BE CONNECTED TO THE GROUNDING WIRE
IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES
BE CUT OR REMOVED.
Warning: Turn off power circuit at the service panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
18. 18. 18. 18. 18. Remove j-box cover as shown in Figure 11.
19. 19. 19. 19. 19. Remove the knockout and install the strain relief (conduit) connector (1/
2") in junction box.
20. 20. 20. 20. 20. Run 3 wires; black, white and green (#16 AWG) in 1/2" conduit from
service panel to junction box.
21. 21. 21. 21. 21. Connect black wire from service panel to black or red in junction box,
white to white and green to green-yellow. See Figure 11.
22. 22. 22. 22. 22. Close junction box cover, check all light bulbs to make sure they are
secure in their sockets, then turn power on in service panel and check
lights and blower operation per Care & Use section of this manual and
install filters.
FINAL ASSEMBLY
23. 23. 23. 23. 23. For final Chimney Cover installation, DO NOT USE ELECTRIC SCREW For final Chimney Cover installation, DO NOT USE ELECTRIC SCREW For final Chimney Cover installation, DO NOT USE ELECTRIC SCREW For final Chimney Cover installation, DO NOT USE ELECTRIC SCREW For final Chimney Cover installation, DO NOT USE ELECTRIC SCREW
DRIVER.
DRIVER. DRIVER. DRIVER. DRIVER.
Raise chimney covers and fasten in place with 2 screws if not already
fastened. Figure 7. Remove one vertical screw holding covers together.
See Figure 10.
Gently slide the outer and middle covers down and set on canopy. Raise
the middle cover, align holes with lower cover and insert pin or wire to
temporarily hold up. Fasten covers together using 2 screws through
holes to permanently hold up.
NOTE: Do not overtighten and deform metal. NOTE: Do not overtighten and deform metal. NOTE: Do not overtighten and deform metal. NOTE: Do not overtighten and deform metal. NOTE: Do not overtighten and deform metal.
24. 24. 24. 24. 24. Make sure to leave this manual for the home owner.
Figure 11 Figure 11 Figure 11 Figure 11 Figure 11