FRIGIDAIRE GLHV30T4KW - Manuel (Page 5)

5
Installation Installation Installation Installation Installation
Pre-Installation consideration Pre-Installation consideration Pre-Installation consideration Pre-Installation consideration Pre-Installation consideration
The hood can be installed to be used in the following ways:
• External exhausting version
• Recycling version (with carbon filter to be ordered from your supplier)
External Exhausting Version External Exhausting Version External Exhausting Version External Exhausting Version External Exhausting Version
The air is expelled outside by means of a pipe to be connected to the coupling
ring B
B B B B (Figure 2).
In horizontal runs, the duct must be slightly slanted (about 10°) and directed
upwards to vent the air easily from the room to the outside.
A non-return smoke valve is supplied as an optional to be mounted on the
coupling flange .
Recycling version Recycling version Recycling version Recycling version Recycling version
The air is filtered through a carbon filter and recycled into the room.
If the hood has no filter ask for one from the technical assistance service or
the manufacturing company, specifying the hood model.
To install the filter, insert it in the place provided and use the two hooks D
D D D D
to fasten it (Figure 4).
The filtered air is discharged above the wall cabinet through the baffle E
E E E E, to
be fastened by means of two screws provided directly on the vertical of the
outlethole of the hood (if necessary fit a duct Ø120mm from the coupling
flange to the upper edge of the hole provided on the top side of the
cupboard (Figure 3).
Figure 2 Figure 2 Figure 2 Figure 2 Figure 2
Figure 3 Figure 3 Figure 3 Figure 3 Figure 3