Faber INCA - Manuel (Page 6)

Version 11/98 - Page 6
Light On/Off Button ( L )
On/Off switch for the fluorescent light. Move the switch to
"1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Set the blower speed control to "1" for LOW speed, "2" for
MEDIUM speed and "3" for HIGH speed.
For Best Results
Start the rangehood before cooking and allow the unit to
operate for several minutes after cooking is complete to clear
all smoke and odors from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot
detergent solution or washed in the dishwasher. Clean ex-
terior surfaces with hot soapy water. Abrasives and scouring
agents can scratch stainless steel finishes and should not be
used to clean finished surfaces.
Replacing the Fluorescent Light
To replace the fluorescent light, remove the retainer clips (T)
from both ends of the glass diffuser as indicated in FIGURE
10. Carefully slide the glass all the way to one end. Lower
the opposite end of the glass below the support flange (L),
then remove the glass by sliding it back. Replace the diffuser
glass by reversing these directions.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel, located on the right-hand side under the
canopy. The position and function of each control button is
indicated in FIGURE 9.
FIGURE 9
FIGURE 10
WIRING DIAGRAM
• This rangehood uses Flourescent Lamp Type F33-15W-T8 and
Starter Type S2.
WARRANTY & SERVICE
This rangehood carries a limited warranty against manufac-
turer's defects. To obtain warranty service, contact the dealer
from whom you purchased the rangehood, or the local Faber
distributor. If you cannot identify a local Faber distributor,
contact Faber USA at (508) 358-5353 for the name of a
distributor in your area.