FRIGIDAIRE 134851000C (0712) - Manuel (Page 3)

CYCLE SELECTION CHART
Estimated Cycle
Duration **
1 hr. 50 min. 45 minutes 48 minutes 36 minutes 35 minutes 33 minutes 12 minutes
Temperatures
Auto Temp Hot/Cold *
Auto Temp Warm/Cold * * *
Auto Temp Warm/Warm
Auto Temp Cold/Cold * *
Tap Cold/Cold
Spin Speed
Maximum * * * *
Fast *
Medium *
Slow *
No Spin
Soil Level
Heavy Soil
Normal Soil * * * * * *
Light Soil
Options & Features
Stain Clean
Extra Rinse
Extended Spin
Signal * * * * * * *
Delay Start
The following chart shows the temperatures, spin speeds, soil levels options and features available for each cycle.
Spin Only Handwash
* Factory Settings Available settings ** Estimated cycle duration is based on factory settings and does not include water fill times, out-of-balance, oversudsing conditions or spin speed selected.
Normal Heavy Duty
Deep Clean
Sanitary
Delicates Perm Press
43 46 30 29 28 48
Drum Light
The drum light will turn on when the washer door is
opened and remain lighted for 3 minutes or until the door
is closed.
Start/Pause
Press Start/Pause to start, pause or restart a cycle. “PAU”
will be displayed alternately with the estimated time
remaining when the cycle is paused.
Cancel
Press Cancel to stop the cycle.
Control Lock
To avoid having someone accidentally start or stop the
washer, press Options and Select at the same time and
hold for 10 seconds until “LOC” is displayed alternately
with the estimated cycle time. To unlock the controls,
press Options and Select at the same time and hold 10
seconds until ”LOC” is no longer displayed.
Estimated Cycle Time
The estimated total cycle time will be displayed when the
cycle is selected.
The time may increase if water pressure is low,
oversudsing occurs or the load becomes unbalanced.
The approximate time remaining will be displayed during
the cycle.
Status Lights
The following will be displayed at the appropriate times
during the cycle:
• Door Lock
• Wash
• Rinse
• Final Spin
* Factory Settings
Available
settings
** Estimated cycle
duration is based on
factory settings and
does not include
water fill times,
out-of-balance,
oversudsing
conditions or spin
speed selected.
PN 134851000C (0712)