Faber Matrix - Manuel (Page 7)

Version 09/05 - Page 7
DUCTED INSTALLATIONS
FIGURE 7
1. For rear ducted installations, attach the rear chimney
transition to the top of the rangehood (FIGURE 7) with the
4 screws provided.
2. If installing the hood with ductwork venting up thru the
ceiling (not to the rear of the hood thru the wall ) , then the
optional chimney covers (purchased separately) can be
attached over the ductwork. Please call 508-358-5353 for
instructions on attaching chimney covers.
FIGURE 8
C
E
H
I
DUCTLESS INSTALLATIONS
1. Screw the ductless grille to the top duct with 4 screws
(part C using the E screws in FIGURE 8).
2. Attach the grille cover (H in FIGURE 7) using the cover
screws (I in FIGURE 8).
3. Attach one charcoal filter to each end of the blower. Each
charcoal filter attaches to the grid on the side of the blower.
Rotate the filter clockwise to install and counterclockwise to
remove (as indicated in FIGURE 9).
FOR ALL INSTALLATIONS
1. Install the grease filters (as indicated in FIGURE 6)
2. Place the 4 ducting panels back onto the hood
(as indicated in FIGURE 5)
3. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does
not operate, disconnect the power supply and check that the
wiring connections have been made properly.
FIGURE 9
WARRANTY & SERVICE
All Faber products are warranteed against any defect in ma-
terials or workmanship for the original purchaser for a period
of 1 year from the date of original purchase. This warranty
covers labor and replacement parts. The warranty does not
cover consumable parts such as filters and light bulbs. This
warranty does not apply if this product has been subjected to
faulty installation, misuse, or neglect. This warranty excludes
any consequential expense or damage resulting from any
use or malfunction of the product. All implied warranties are
limited to the duration of this warranty.
To obtain warranty service, contact the dealer from whom you
purchased the rangehood, or the local Faber distributor. If you
cannot identify a local Faber distributor, contact us at (508)
358-5353 for the name of a distributor in your area.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
Remote Control
The rangehood can be controlled using the enclosed remote
control which has the same control layout (as indicated in
FIGURE 11). The remote uses alkaline AAA type batteries. To
replace the batteries, remove the cover by removing the screw
and sliding off the cover (as indicated in FIGURE 10). Do not
place the remote control close to heat sources.
FIGURE 10