Hamilton Beach 840087000 - Manuel (Page 8)

8
Retractable Cord
(not available on all models)
1. Press and hold the Cord Release
Button while
pulling cord to
desired length.
Do not unwind
cord beyond the
tape indicator
on the cord.
2. To store cord, place the iron, sole-
plate down, on
ironing board.
Unlatch
Retractable
Cord Handle
and wind
clockwise.
IMPORTANT! Do not press Cord
Release Button while winding cord.
Only wind clockwise or the cord may
jam. See illustration.
3. If cord jams while winding, push the
Cord Release Button to unwind
slightly until cord is free. Then slowly
start to wind clockwise again.
If Retractable Cord Handle
comes off, it is designed to snap
back in place.
1. Place pins of handle into slots in reel.
See illustration.
2. Lift handle up until it snaps in place.
Quick Storage Shield
There is no need to wait for the iron to
cool before storing.
Make sure the iron
has been turned off
and unplugged.
Then, place the
Quick Storage
Shield on the iron
immediately after
ironing.
CAUTION: The soleplate may be hot,
so care must be used in placing the
Quick Storage Shield on the soleplate.
Caring for Your Iron
Soleplate
1. Never iron over zippers, pins, metal
rivets, or snaps, as these may
scratch the soleplate.
2. To clean occasional build-up on the
soleplate, wipe with a sudsy cloth.
Do not use abrasive cleansers or
metal scouring pads. Do not
immerse in water.
3. Always store iron upright in the heel
rest position.
Iron
1. The water tank of your iron should
be emptied after each use. Turn
Temperature Control Dial to Off.
Unplug the iron and hold over a sink.
Slowly tilt pointed end of iron
down over sink. Water will run out
of water tank opening.
2. After iron has completely cooled,
wrap cord loosely around the iron
and store in an upright position. Do
not store iron laying flat on soleplate.
Optional Features
(continued)
Cord
Release
Button
Wind
clockwise
Retractable
Cord Handle