Focal Bathys Noise-Canceling Wireless Over-Ear Headphones (Black/Silver) - Manuel (Page 15)

EN Warning symbol. This symbol is designed to warn the user of the presence
of important instructions mentioned in the user manual and relating to the
handling, operation and maintenance of the device.
Do not short-circuit the (+) and
(-) terminals of the battery with
conductive elements (in contact with
metallic objects in particular), or by
any other means.
Do not reverse the polarities.
Do not place burning objects near
and/or on the headphones’ built-in
battery. In general, the battery should
not be exposed to excessive heat
such as sunshine, fire or similar (above
70°C) and/or humidity above 90%.
Do not expose the battery and
charger to water (do not immerse,
pour liquid on them, expose to
condensation or get wet). Do not
expose to rain.
Never use a damaged battery.
Do not subject the battery to impacts
or vibrations. In the event of a severe
impact, stop using the battery.
Do not destroy or incinerate the
battery.
Exposure to internal battery
components or the products released
when burned can be hazardous. If you
have been exposed, contact your GP.
If, during use, the battery gives off an
unusual odour or becomes abnormally
hot or warped, switch off the device
immediately and contact your Focal
dealer.
Only use this product with a certified
Limited Power Supply (LPS) that
meets local regulatory requirements
(e.g. UL, CSA, VDE, CCC & CE).
Only charge the battery at an ambient
temperature between 0°C and 45°C.
Never charge a swollen, leaking or
otherwise damaged battery.
Never use a modified or damaged
charger. Only charge the battery
on non-flammable surfaces (do not
charge it on a flammable surface
such as carpet or wooden floors)
and do not charge it near flammable
materials. Charge the battery on a
non-conductive surface to prevent any
damage associated in particular with a
short circuit.
Keep the battery and charger out of
the reach of children under 14 years
old.
Do not use the headphones while the
battery is charging.
Any battery (original or replacement)
should not be exposed to heat such as
sunshine, fire or similar.
OPTIMAL CONDITIONS FOR
BATTERY USE
For your headphones’ battery to
retain optimal autonomy, and in the
event of prolonged non-use, recharge
it regularly and at least once every
three months or so.
Turn off battery-powered products
when not in use.
For optimal use, do not use
headphones with a battery in places
subject to excessive heat (above
40°C) or excessive cold (below -5°C).
In the event of a problem, contact
your specialist dealer.
- The replacement of a battery with an
incorrect type can defeat a safeguard
(for example, in the case of some
lithium battery types);
- the disposal of a battery into fire or
a hot oven, or mechanically crushing
or cutting of a battery can result in an
explosion;
- leaving a battery in an extremely
high temperature surrouding
environment can result in an explosion
or the leakage of flammable liquid
or gas;
- a battery subjected to extremely low
air pressure may result in an explosion
or the leakage of flammable liquid
or gas.
FCC Regulatory Compliance
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
changes or modifications not
expressly approved by the party
responsible for compliance could void
the user’s authority to operate the
equipment.
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth for
an uncontrolled environment. This
transmitter must not be co-located
or operating in conjunction with any
other antenna or transmitter.
ISED Regulatory Compliance
This device contains licence-exempt
transmitter(s)/receiver(s) that
comply with Innovation, Science and
Economic Development Canada’s
licence-exempt RSS(s). Operation
is subject to the following two
conditions: (1)This device may not
cause interference.(2)This device
must accept any interference,
including interference that may cause
undesired operation of the device.This
equipment complies with IC RSS-102
radiation exposure limits set forth for
an uncontrolled environment.