Emerson EC313D - Manuel (Page 11)

- 11 - EN
0B19
CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown here.
By using this connection you can also record scram-
bled channels. However, channel selection must be
made with the converter box or satellite box. This
means that channels cannot be changed using the
TV/VCR Remote Control. Unattended timer record-
ing is limited to one channel at a time.
IN
OUT
ANT.
AC 120V DC 13.2V ANT.
From Cable System
or Satellite Dish
75-ohm Coaxial
Cable
(Not supplied)
Satellite Box or
Cable Box (Not supplied)
TO RECORD A SCRAMBLED/UNSCRAM-
BLED CHANNEL
1. Set the TV/VCR channel selector to the output
channel of the Cable Converter Box or Satellite
Box. (Ex. CH3)
2.Select the channel to record from your Cable
Converter Box or Satellite Box.
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing
the cover on the remote unit in the direction of the
arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.
EXTERNAL INPUT MODE
When using an external input signal (another VCR or
video camera), connect the player’s audio/video out-
put cables to the AUDIO IN/ VIDEO IN jacks of
your TV/VCR. Then press the CHANNEL K or L
button until “AUX” appears on the
screen.
AUX
MOBILE CONNECTION
NOTES:
• Be sure your vehicle has a 13.2-volt, negative-
ground electrical system.
• Be sure you use only the supplied car battery cord.
Using another cord could damage the TV/VCR.
• Be sure the socket is free of ashes and other debris.
• Be sure to push the car battery cord’s plug com-
pletely into the cigarette-lighter socket.
• Always unplug the car battery from the cigarette-
lighter socket before you unplug it from the
TV/VCR.
• You must disconnect the car battery cord from the
TV/VCR before you can use the AC power.
• Be sure to replace the fuse with only the same
type, 5A, 250V.
• Do not touch the metal parts of plug immediately
after a car battery cord is disconnected. Because
they become hot.
ANT.
ANT.
AC 120V DC 13.2V
VHF/UHF Combination
Mobile Antenna
(Not supplied)
Car battery cord
(Supplied)
To the vehicle's
cigarette-lighter socket
DC13.2V
1)The supplied indoor antenna is adequate when
your vehicle is stationary. For best reception on
the road, use a high-quality VHF/UHF mobile TV
antenna.
2)Attach the car battery cord to the DC13.2V con-
nector on the back of the TV/VCR. Then, connect
the other end to your vehicle’s cigarette-lighter
socket.
WARNING: The driver should never watch
the TV/VCR while operating a motor vehicle.
CAUTION: If you use the TV/VCR with the
vehicle’s engine off, recharge the vehi-
cle’s battery after about every 4 hours of
use to prevent it from running down. After
you finish using the TV/VCR be sure you
unplug the car-battery cord from the ciga-
rette-lighter socket.