Livarno Z31685A, Z31685B, Z31685C, Z31685D - Manuel (Page 9)

9 GB/IE
Avoid contact with the skin, eyes and mucous membranes. In
the event of contact with battery acid, thoroughly flush the
affected area with plenty of clean water and seek immediate
medical attention.
Only use the same type of batteries. Do not mix used and
new batteries.
Avoid extreme conditions and temperatures which may impact
batteries, e.g. on radiators.
Remove the batteries if the appliance has not been used for a
long period.
Risk of equipment damage
Only use the specified battery type!
When inserting the battery ensure the correct polarity! This is
shown in the battery compartment.
If necessary, clean the batteries and device contacts before
inserting batteries.
Promptly remove drained batteries from the product.
Mounting the light
Note: You will need an electric drill to install the light.
CAUTION! RISK OF INJURY! Refer to the operating instructions
for your electric drill.
CAUTION! Ensure that you do not damage any cables in the wall.
Please see figure A (with screws and dowels) or B
(with adhesive tape) for mounting the light.
Note: The substrate should be dry, smooth and free of dust
and grease.
Note: For the first 24 hours after installation do not remove
the self-adhesive pad. Otherwise the self-adhesive pad will
lose its ability to stick.