Tips, Trouble- shooting, Getting started – Excalibur electronic 9442-CC Manuel d'utilisation

Page 4: English

Advertising
background image

Tips

If your vehicle does not

respond to the transmitter,

move closer to your 1:12

Ford GT and try again.

If your vehicle starts to

lose power, it may experi-

ence loss of performance. If

this happens, simply re-

place with the new batteries.

If your vehicle moves

slowly, try changing the

batteries and check the

wheel mechanisms for lint,

thread, hair or dust.

When the transmitter

range decreases, replace the

battery in the controller. If

someone uses a CB nearby,

it might interfere with con-

trol of the car. If this hap-

pens, move the car and

transmitter away from the

CB.

Trouble-

shooting

If your 1:12 Ford GT

doesn’t move, please check

the following potential

causes:

1. The

POWER

switch is

turned off. If that is the

case, turn the

POWER

switch

on.

2. Your 1:12 Ford GT is

too far away from the con-

troller. If that is the case,

bring your 1:12 Ford

Mustang closer to the con-

troller.

3. The metal tab in the

battery cartridge is flattened

and not touching the batter-

ies installed. If that is the

case, lift up the metal tab so it

touches the tip of the battery.

Getting

Started

To begin, insert the

antenna wire through the

hollow tube. Avoid pulling

the wire too tight. The wire

is on the top of your 1:12

Ford GT. Tie a knot on top

to secure.

Turn the switch to the

ON

position for power.

Use the control switches

on the transmitter to drive

your 1:12 Ford GT. It will

allow you to drive it for-

ward, reverse, left and right.

Use both control switch-

es to turn. If you want to

turn right while driving for-

ward, push the right switch

right and push the left

switch up. If you want to

turn left while driving in

reverse, push the right

switch left and push the left

switch back.

6

7

Changes or modifications to this unit not

expressly approved by the party responsible

for compliance could void the user’s authority

to operate the equipment.

Trim switch is located on the underside of

the vehicle, between the two front wheels and

is used to align the wheels for consistent

straight line driving.

ENGLISH

ENGLISH

Advertising