Curtis RPW250 - Manuel (Page 11)

Malfunction display and solutions
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine
without permission.
If the washer can not work normally, and the abnormal indication is shown in the digital
display window or the machine alarms, please check and correct as follows.
18
Water injection for about
30 minutes, but do not
reach preset water level “E1” flares, and
other lights are
turned off.
After draining for 10
minutes, does not finish
draining.
Fault Cause of fault Indication
Alarm of the
buzzing sound
Stopping alarm
Alarm for
water inlet
Alarm for
opening lid
Imbalance
alarm
Drain
alarm
“E2” flares, and
other lights are
turned off.
“E3” flares, and
other lights are
turned off.
“E4” flares, and
other lights are
turned off.
“E5” flares, and
All water lever
lights flash.
Overflow
alarm
Note: 1: alarm removed, the return to the status before the alarm; E3 failures appear in the same trip.
2: overflow alarm, automatic water drain valve open until the manual intervention contact failure.
Open the lid after starting
the delay time. Open the lid
when the washer is spinning.
Open the lid when entering
into the child lock state.
Water level is higher than
rated overflow level 1:Power off
2:repair
Technical specifications
Technical specifications
601X615X1015
45kg
4.2A 2.5Cu.ft
120
Current
value
Drum Size
Not normally open or
unlocked door
the door can be open only by
pull up the power when the
door is locked, and it can
power-off and alarm-cleared
by press the power key when
the door lock is open.
“E6” flares, Door-lock
failure
19