Curtis SDVD9000B2-D-BLACK - Manuel (Page 18)

17
- - General Setup Page - -
Go To General Setup Page
TV Shape Wide
Angle Mark On
OSD Lang
Eng
Screen Saver On
Setting Menus:
◄, ►, ▲, ▼
need to set or reset. Press the OK
Button to enter or confirmed the selection. After setting, press the SET UP Button to save the settings and exit.
In stop playback mode, press the SETUP Button the setting menu will appear on the screen as below. Using the
Direction Buttons to select and highlight the function you
In General Setup Page:
the multi-angle logo will appear on the screen.
or the image is paused for approximately five minutes.
On or Off. If set to On, when
multi-angles are available in the playing DVD,
Direction and OK Buttons to set the
OSD language as desired.
Off. If set to On, the
screen saver will come on when the unit stops
it On or
5. If Last Memory is selected, using the Direction and OK Buttons to set it On or Off. If set to On, the unit
will start playback from the position where the disc was stopped last time.
1. If TV Shape is selected, using the Direction and OK Button to set the aspect ratio to match the
connected TV.
2. If Angle Mark is selected, using the Direction and OK buttons to set it
OSD Lang (On Screen Display Language) is selected, using the 3. If
4. If Screen Saver is selected, using the Direction and OK Buttons to set
In Audio Setup Page:
menu will appear.
to Lt/Rt; Stereo.
If Speaker Setup is selected, press the OK Button, the sub-setting
1. If Downmix is selected, using the Direction and OK Buttons set it
~ If set to Lt/Rt, the rear left or rear right channels will plays on both Left and Right Speakers.
~ If set to Stereo, the rear left channel will plays on Left Speaker; the rear right channel will plays on Right
Speaker.
In Dolby Setup Page:
channel on all speakers) or Mix-Mono
plays on all speakers) as desire. (Functions depend on the recording of the disc).
to Stereo, L-Mono (Play Left
channel on all speakers), R-Mono (Play Right (Mixed Right and
Left channel then
1. If Dual Mono is selected, using the Direction and OK Buttons to set it
2. If Dynamic is selected, using the Direction and OK Buttons to set the dynamic level as desired or turn
it off.
SYSTEM SETUP
Last Memory Off