Curtis SIP115 - Manuel (Page 4)

Unit gets warm after extended play at high volume
Solution Possible problem
As with other devices, this is normal
when the unit is played at loud
volumes for an extended period of
time
Lower the volume or turn the unit
off for a short period of time
Sound source is distorted
Distortion
Solution Possible problem
If the original source (MP3) is
poor quality, distortion and noise
will be noticed with
high powered speakers.
Volume level on unit is set too high Press the VOL- to lower the volume
Maintenance
This product was designed and manufactured to meet the strict guidelines
of engineering, fabrication and quality control .
Please look after the product in order to maintain its performance.
Steps to take into account include:
Use a soft dry cloth to clean the enclosure of the unit.
Never use cleaners, liquids or abrasive substances on its surfaces.
Operate or store in a cool, dry place.
Do not block the ventilation openings on the unit.
Placing in a secure surface, in order to avoid being dropped and damaged.
Always refer to the safety instructions provided in this Manual.
Troubleshooting
No power
Solution
AC adaptor is not connected to a
wall outlet and/or the power supply
connector is not plugged into supply
jack on the back of unit.
Connect the AC adaptor jack plug
into the’DC in’ jack on the rear of
the unit labeled “Power” and then
plug the AC adapter into the wall
outlet.
Wall outlet is not functioning Plug another device into the same
outlet to confirm the outlet is
working.
Possible problem
No sound from speakers
Solution Possible problem
Volume is set too low
Press the VOL+ to increase the
volume
iPod is not docked correctly Remove your ipod from the dock
well and re-dock to make sure it
is properly connected.
5 6
Specification
Power supply: ac 100V-240V 50-60Hz DC 9V 1000mA
Output power: 2X4 watts RMS
Speaker unit dimension: 2”
Specification subject to change without further notice.