Curtis RIC102 Manuel d'utilisation

Page 6

Advertising
background image

Press the Power Button and the green indicator light will remain on.

To change between either the small or large ice size, press the Select

Button until the light is lit up beside the desired ice size.

The first ice making cycle will last approximately 6 - 13 minutes

depending on the ice size that is selected. The ice making cycle starts

with water being pumped into the Water Tray situated below the

Evaporator Fingers. Over the next 6 - 13 minutes ice forms on the

Evaporator Fingers. Once this has completed, the Ice Tray will tilt

backwards and the remaining water in the Ice Tray is drained back into the

Water Reservoir. The ice cubes are then dropped from the Evaporator

Fingers and pushed forward into the Ice Basket by the Ice Shovel. The Ice

Tray will automatically move back into position under the Evaporator

Fingers and start the next cycle.

The 'Ice Full' LED light will light up when the ice basket is full and the Ice

Maker will stop the ice making cycle automatically. Gently remove the ice

from the Ice Basket with the Ice Scoop. Once the Ice Basket has been

emptied and the Cover closed, the Ice Maker will restart its ice making

function automatically. IMPORTANT: Wait 3 minutes then press the

Power Button to restart the ice making function.

The ‘Add Water’ LED light will light up when there is no more water in

the Water Reservoir and the ice making cycle will stop automatically. Press

the Power Button once (the Power Button will flash every 5 seconds).

Remove the Ice Basket and add water to the Water Reservoir.

NOTE: Do not fill above the MAX water level mark at the back of the

Water Reservoir. Replace the Ice Basket and close the Cover.

IMPORTANT: Wait 3 minutes then press the Power Button to restart the

ice making function.

When you have finished making ice, transfer the ice to a freezer.

NOTE: The ice will last in the Ice Maker for up to a 18 hour period,

depending on the ambiant temperature. Stop the ice making cycle by

pressing the Power Button. Unplug the unit from the wall outlet.

Open the Cover and allow the Ice Maker to reach room temperature

and follow the directions in the Care and Cleaning section.

6.

7.

8.

9.

10.

5

Advertising