Curtis MIS1530 Manuel d'utilisation

Page 5

Advertising
background image

4

English

Electrical Requirement

• Make sure there is a suitable power outlet (115 volts, 15 amps

outlet) with proper grounding to power the beverage and wine center.

• Avoid the use of three prong adapters or cutting off the third

grounding prong in order to accommodate a two prong outlet. This is

a dangerous practice since it provides no effective grounding for the

beverage and wine center and may result in shock hazard.

• Do not install your beverage and wine center in any location not

properly insulated or heated (e.g., garage etc.). Your beverage and

wine center was not designed to operate in temperature settings below

55˚ Fahrenheit.

• Select a suitable location for the beverage and wine center on a

hard even surface away from direct sunlight or heat source (e.g.,

radiators, baseboard heaters, cooking appliances, etc.). Any floor

unevenness should be corrected with the leveling legs located on the

front and rear bottom corners of the beverage and wine center.

• Your beverage and wine center

is designed for freestanding

installation only. It is not designed for built-in application.

Note: This unit is for indoor use only.

• Avoid the use of an extension cord because of potential safety

hazards under certain conditions. If it is necessary to use an extension

cord, use only a 3-wire extension cord that has a 3-blade grounding

plug and a 3-slot outlet that will accept the plug. The marked rating

of the extension cord must be equal to or greater than the electrical

rating of the appliance.

Installation Limitations

Use of Extension Cord

WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD

Advertising