Curtis FRW216 Manuel d'utilisation
Page 16
You cansolvemanycommonthermoelectriccellarproblemseasily, savingyou the cost of a
possible service call. Try the suggestion below to see if youcansolve the
problembeforecalling service center.
PROBLEM POSSIBLE
CAUSE
thermoelectriccellar do not
operate.
Not plugged in usingdifferent voltage. The circuit
breakertripped or ablown fuse.
thermoelectriccellaris not cold
enough.
Check the temperature control setting.
Externalenvironmentmayrequire a higher setting.
The dooris open toooften.
The dooris not closedcompletely.
The doorsealdoes not sealproperly.
The thermoelectriccellardoes not have the correct
clearance.
The light does not work.
Check the service center.
Vibrations.
Check to assure that the
thermoelectriccellarislevel.
The thermoelectriccellarseems to
make to much noise
The thermoelectriccellaris not level.
Check the fan.
The doorwill not close properly.
The thermoelectriccellaris not level.
The doorswerereversed and not properlyinstalled.
The sealisweak.
The shaves out of position.
LED could not display.
Main control boarddoes not work.
PCB Problem.
There issomeproblemwith the plug.
LED display error.
Weakquality of display.
Temperature point is out off.
Bottoms are not functional.
Temperaturecontroller panel isdamaged.
X SERVICE & IMPORTANT NOTICE
1, This machine isdesigned to beonlyused in “N” climate class (16-32°C)
2, Uponreceipt and inspection of the unit, If the supplycordisdamaged, it must bereplaced