Eiki LC-XG300 EN - Manuel (Page 25)

25
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights green.
Press the ON/STAND-BY button on the top control or
the ON button on the remote control. The LAMP
indicator lights red and the cooling fans start to operate.
The preparation display appears on the screen and the
count down starts.
2
3
1
The preparation display will disappear
after 30 seconds.
4 After the countdown, the input source that was
selected the last time and the lamp control status icon
(see page 54) appear on the screen.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed below.
Selected Input Source and Lamp Control
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Lamp control status
What is PIN code?
PIN (Personal Identification Number) code is a security code
that allows the person who knows it to operate the
projector. Setting a PIN code prevents unauthorized use of
the projector.
A PIN code consists of a four-digit number. Refer to the PIN
code lock function in the Setting Menu on pages 60–61 for
locking operation of the projector with your PIN code.
After the OK icon disappears,
you can operate the projector.
PIN Code Input Dialog Box
Turning On the Projector
Basic Operation
Enter a PIN code
Use the Point ed buttons or Number buttons on the remote
control to enter a number. Press the Point 8 button to fix the
number and move the red frame pointer to the next box. The
number changes to “
✳.” If you fixed an incorrect number,
use the Point 7 button to move the pointer to the number
you want to correct, and then enter the correct number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
“Set.” Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect PIN code, “PIN code” and the
number (
✳✳✳✳) will turn red for a moment. Enter the correct
PIN code all over again.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take a special care in setting a
new PIN code; write down the number in a
column on page 81 of this manual and keep it at
hand. Should the PIN code be missing or
forgotten, consult your dealer or service center.
✔
Notes:
•When the Logo select function is set to “Off,”
the logo will not be shown on the screen (p.55).
•When the “Countdown off” or “Off” is selected
in the Display function, the countdown will not
be shown on the screen (p.57).
•During the countdown period, all operations are
invalid.
•If the correct PIN code number is not entered
within three minutes after the PIN code dialog
box appeared, the projector will be turned off
automatically.
•The “1234” is set as the initial PIN code at the
factory.
See page 54 for the Lamp control status.
✔
Note:
•The Filter warning and Lamp replacement icons
may appear on the screen depending on the
usage state of the projector.
16