Eiki LC-XG300 EN - Manuel (Page 70)

70
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Appendix
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Some displays are not seen – Check the Display function. See page 57.
during the operation.
PIN code dialog box appears – PIN code lock is being set. Input a PIN code (the “1234” or numbers
at start-up. you have set). See pages 25, 60–61.
The Remote Control does – Check the batteries.
not work. – Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4’ (5 m).
– Make sure that the remote control code conforms to the projector’s
code. See page 57.
– Unlock the Key lock function for the remote control. See page 59.
Cooling fans are still running after – This is a normal condition. The fans are running about one minute
the AC power cord is unplugged. even after disconnecting the AC power cord.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.