DCS RGT-486GD - Manuel (Page 15)

13
INSTALLING ANTI-TIP DEVICE
All ranges must have an anti-tip device correctly
installed as per the following instructions. If you pull
the range out from the wall for any reason, make sure
that the device is properly engaged when you push
the range back against the wall. If it is not, there is a
possible risk of the range tipping over and causing
injury if you or a child stand, sit or lean on an open
oven door.
INCLUDED PARTS:
(4) #10 x 2” wood screws,
(1) Anti-tip bracket, and (1) Installation Instructions.
INSTALLING THE KIT:
Instructions are provided for wood and cement
floors. Any other type of construction may require
special installation techniques as deemed necessary
to provide adequate fastening of the Anti-tip bracket
to the floor and wall. The use of this bracket does
not preclude tipping of the range when not properly
installed.
WOOD CONSTRUCTION:
Place the bracket against the back wall, into the right
rear corner where the range is to be located. Leave a
gap between the wall (or side of range) and the bracket
(see fig. 8). Drill (2) 1/8” diameter pilot holes in the center of
the small holes. A nail or awl may be used if a drill is not
available. Fasten the bracket securely to the floor and wall.
CONCRETE OR CEMENT CONSTRUCTION:
Hardware Required:
(2) sleeve anchors, lag bolts, and washers (not provided).
Locate the bracket as described above. Drill the recommended
size holes for the hardware. Install the sleeve anchors into the
holes and then install the lag bolts through the bracket. The
bolts must be properly tightened as recommended for the
hardware. Fasten the bracket securely to the floor and wall.
ONCE INSTALLED:
Complete the range installation per the instructions provided
with the product. Check for proper installation of the range and
Anti-tip device by grasping the back of the unit and carefully
attempt to tilt the range forward.
WARNING
ALL RANGES CAN TIP
INJURY COULD RESULT
INSTALL ANTI-TIP
BRACKET PACKED
INSIDE OVEN
SEE INSTRUCTIONS
Fig. 9
Fig. 8
(2) Large Holes for Concrete
Installations
(2) Small Holes for Wood
Installations
(2) Wood Screws into Back
Wall (ALL Installations)
BACK
WALL
RIG
HT
SID
E O
F
WA
LL
OR
RA
NG
E
A
Model
Series
RGT-48 RGT-36 RGT-305
A 1/2” 5/8” 7/8”