DCS WOT-230 - Manuel (Page 10)

8
MOUNTING THE WALL OVENS
FIG. 4
L1 COMMON L2 GROUND
RED WHITE BLACK
Our built-in ovens require a dedicated and properly grounded 4-wire 120/240 volt, 60 Hz power supply, protected
by a time delay fuse or circuit breaker. Ovens are supplied with a flexible power cable which must be hard wired
to a junction box.
AMPERAGE:
■ WOT/WOTD-227& WOT/WOTD-230 = 50A
■ WOT-127& WOT-130 = 35A
WARNING !
Electrical Shock Hazard!! Follow these instructions!
CAUTION!
If the power leads are connected improperly (reversing L1 and N, or L2 and N (fig. 1), damage to the oven will result.
■ The electrical power to the oven branch circuit must be shut off while line connections are
being made.
■ Use the proper sized copper wiring only.
■ Electrical grounding is required on this appliance. The free end of the bare copper ground
wire must be connected to a suitable ground. This wire must remain grounded to the oven.
■ If cold water pipe is interrupted by plastic, non-metallic gaskets, union connections or other
insulating materials, Do Not use for grounding.
■ Do Not ground to a gas pipe.
■ Do Not have a fuse in the Neutral or Grounding circuit. This could result in an electrical shock!
■ If you are in any doubt as to whether the appliance is properly grounded, check with a
qualified electrician.
MOUNTING THE WALL OVEN:
WARNING:
Failure to follow these instruction could result in serious injury or death!
1 Remove all cardboard, packing materials, the bottom wood pallet and metal mounting brackets. Remove the oven
doors and oven racks (see Use & Care manual page 18).
2 After creating your precision cabinet cutout and supports, position the oven in front of the cutout. Make the
power supply connections as specified in this guide, and then slide the unit carefully into the cabinet opening.
3 When in place, drill 3/32” holes into cabinet frame through the mounting holes in the oven side trim. See fig. 2.
4 Secure oven to the cabinet with screws furnished as shown in figure 3 (uses 2 screws, 1 on each side, top oven
only).
5 Slip tabs on rear of bottom trim into mating slots in oven trim posts (see fig.4). Attach the bottom trim with the 2
screws provided.
FIG. 1
4-WIRE CONNECTIONS
FIG. 3 FIG. 2