Danby DPAC5009 - Manuel (Page 5)

Air Conditioning Mode ONLY: Your window kit
has been designed to fit most standard “vertical”/
”horizontal” windows up to a maximum height of 80”
(203cm). For vertical window applications, multi lock
positions are provided on the edge of each slider
section to secure each sliding section together.
1) Select a suitable location, making sure you have
access to an electrical outlet.
2) Install the flexible hose to the rear side of the unit.
Insert the hose collar on top of the exhaust opening
and twist to lock into position.
3) Install the adjustable Window Slider Kit as
required (see Fig. 4a & 4b).
4) Install the opposite end of the flexible exhaust
hose into the window exhaust adapter.
5) Install the window exhaust adapter into the
opening in the slider section, making sure the
window slider sections are secure.
6) Plug the unit into a 115V/60Hz grounded electrical
outlet.
Window Slider Kit:
Min.: 28
1
/3” (67.5cm)
Max.: 80” (203cm)
Window Slider
Kit:
Min.: 28 1 /
3
”
(72cm)
Max.: 80”
(203cm)
Horizontal Window
Vertical
Window
WINDOW KIT
INSTALLATION
Back of window panel
Tube Adapters
Fig. 2
Instructions for Assembling the Window Kit- Fig. 2
1) Insert tube adapters through the back of the window panel.
2) Secure each tube adapter with four screws through the front of the
window panel.
3) Insert window panel extensions into window panel. Lightly tighten the
screws in the window panel to hold the extensions in place.
Fig 3a Fig 3b
4
INSTALLATION
ELECTRIC SHOCK HAZARD: To avoid the possibility of
personal injury, disconnect power to the unit before installing or
servicing.
Caution: To avoid installation/operation difficulties, read these
instructions thoroughly.
Flexible Exhaust Hose (13cm) & Exhaust nozzle connector (2
pcs)... from 17 7 /
10
(45cm) to 53 1 /
6
” (135cm)
Flexible Exhaust Hose (11cm) & Exhaust nozzle
connector (2pcs)...from 15 3 /
4
” (40cm) to 51 1 /
5
” (130cm)
Adjustable window door slider kit (3 pcs)... from 28 1 /
3
”(72cm) to
80” (203cm)
Fixture..... (2 pcs) & Screws..... (8 pcs)
NOTE: The exhaust/window kit must be installed at all times when
the unit is operating under AIR CONDITIONING mode. There
should be at least 11.8” (30cm) clearance between the unit and any
other objects or building structures, and should be installed on a
level surface.
Fig. 1 INSTALLATION ACCESSORIES
Flexible Exhaust Hose
Exhaust Nozzle
Connector
Fixture
Adjustable Window Slider Kit:
28 1/3” (72cm)- 80” (203cm)
Screws
Water hose (79”/ 200cm)