DCS WDS-30 - Manuel (Page 8)

MOUNTING INSTALLATION
The lower rear corners of the cabinet need to provide proper support to the back of the Warming
Drawer and the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36
inches from the back center of the Warming Drawer. Illustrations suggest one possible bottom
support, but the consumer is not limited to this idea for mounting configuration.
STEP 1
The bottom rear section of the cabinet should be made of solid plywood or 2x4 and needs to be
installed to hold the anti-tip mounting clips and support the weight of Warming Drawer, which is
90 lbs.
STEP 2
Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the
bottom support at the back. See placement dimensions in figure below.
STEP 3
The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips.
See page 8. Plug power cord into AC outlet.
STEP 4
Fasten the front face to the cabinet by passing the screws through the holes of the front face of the
warming drawer to finish the installation. See page 8.
NOTE: Bottom support made of plywood or other solid wood construction capable of supporting
the weight of the warming drawer.
INSTALLATION INSTRUCTIONS
7
Slide drawer
on to Anti-Tip
mounting clips
mounting clips
WDS – 21-1/2"
WDI – 21-7/8"
Fig. 05