Paradigm Studio CC-690 v5 - Manuel (Page 9)

Fig. 8e
ADJUST BRACKETS TO ACHIEVE
DESIRED ANGLE OF TILT:
a) Tilt speakers inward for better imaging;
b) Tilt center speaker up or down to optimize clarity and
intelligibility or;
c) Mount speaker parallel to the wall (horizontally or
vertically), using bracket at the 0° position.
Align screws with desired angle position (refer to
information at far right) and screw in.
Fig. 8f
Connect speaker following the information included
later in the manual.
(Vertical Placement)
Using an "in and sideways" motion slide speaker
onto bracket; tighten assembly locking screw.
Fig. 8g (Horizontal Placement)
Using an "in and down" motion slide speaker onto
bracket; tighten assembly locking screw.
Minimum clearance
between edge of TV and
center of bracket is 6-7/8˝ (175 mm)
Minimum clearance
6-7/8˝ (175 mm)
9