Paradigm RVC-12SQ - Manuel (Page 5)

5
Break-In
Allow your Paradigm ® Reference subwoofer system to operate for several hours before you listen critically.
Cleaning
Clean subwoofer housing with a soft, damp cloth. Do not use a strong or abrasive cleaner or get any part of
the subwoofer wet.
If you wish to paint your subwoofer you must do so before installing it. See the section on ”Color Match
Painting” later in this manual for full details.
Optional Paradigm ® Backbox
Paradigm ® Reference in-wall subwoofers can also be installed into an optional Paradigm ® Backbox (sold
separately). If you decide to use a backbox, follow the instructions for placement and installation included with
the backbox. NOTE: If you install your subwoofer into a Paradigm
® Backbox, you will not require the MDF
mounting frame that came with your subwoofer.
YOUR NEW SUBWOOFER
Setting 1: Use this setting with one RVC-12SQ subwoofer without a backbox
Setting 2: Use this setting with one RVC-12CF subwoofer with or without a backbox
Setting 3: Use this setting with one RVC-12SQ subwoofer with a backbox
NOTE: These settings are also displayed on your amplifier’s back panel.
WARNING: The following procedures are imperative for correct system
setup. Failure to follow the instructions that apply to your setup will result
in permanent damage to amplifier and subwoofer. Such damage is NOT
covered under the Paradigm warranty.
1. The Impedance Matching Switch on Your Subwoofer’s Baffle:
To prevent damage to amplifier or subwoofer, the Impedance Matching Switch on your subwoofer’s
baffle must be correctly positioned (Fig. 1).
2. Using the Paradigm ® X-300 Amplifier with Your Subwoofer:
To prevent damage to amplifier or subwoofer and ensure optimal sound, the 3-Position “EQ” Switch on
the X-300 amplifier’s rear panel must be correctly configured for use with or without a Paradigm
® Backbox.
Toggle to the setting that matches your setup (Fig. 2):
3. Using the Paradigm ® X-850 Amplifier with Your Subwoofer:
Your X-850 amplifier comes with a Setup CD that allows you to configure your Paradigm ® Reference
subwoofer system for optimal sound . PC requirements for running this CD are Windows XP or Vista and
one USB port. Install the software and perform the setup before connecting your amplifier to
the subwoofer. For complete instructions on installing the software, refer to the Owners Manual that
came with your X-850 amplifier.
CONFIGURING THE AMPLIFIER FOR USE WITH YOUR
SUBWOOFER