Paradigm Monitor SUB 8 - Manuel (Page 2)

TABLE OF CONTENTS
RECYCLING AND REUSE GUIDELINES FOR EUROPE
In accordance with the European Union WEEE (Waste Electrical and Electronic Equipment) directive effective August 13, 2005, we would
like to notify you that this product may contain regulated materials which, upon disposal, according to the WEEE directive, require special
reuse and recycling processing. For this reason Paradigm Electronics Inc. (manufacturers of Paradigm
® speakers and Anthem ™ Electronics)
has arranged with our distributors in European Union member nations to collect and recycle this product at no cost to you. To find your
local distributor please contact the dealer from whom you purchased this product or go to our website at www.paradigm.com.
Please note that the product only falls under the WEEE directive. When disposing of packaging and other shipping material we encourage
you to recycle through the normal channels.
IMPORTANT OPERATING INFORMATION
READ BEFORE OPERATING YOUR NEW SUBWOOFER
INITIAL OPERATION
The LED on the subwoofer’s front panel will only turn on when it senses a signal. In wireless operation, once the PT-2
transmitter is plugged in and in search mode, synching with the subwoofer occurs within 60 seconds. When the subwoofer
senses the wireless signal from the PT-2 its LED automatically turns on.
SUBSEQUENT OPERATION
Your subwoofer is equipped with an advanced power saving mode. After about 20 minutes with no input
signal the sub will enter a low-power (i.e. standby) state, at which time the blue LED on the front panel will
turn off. When an input signal is received, the subwoofer will automatically turn on again and the LED will
glow blue. The LED will only begin flashing if the subwoofer is intentionally re-synced with a PT-2 Wireless
Transmitter or during the Paradigm Perfect Bass Kit (PBK) optimization procedure.
PRODUCT CONSUMES LESS
THAN 1 WATT IN STANDBY.
This device contains FCC ID: YZY-HT205 and IC ID: 9261A-HT205. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Any changes or modifications of this product, not approved by the manufacturer,
may void the user’s authority, to operate the equipment.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Important
Safety Precautions . . . . . . . . . . . . . . 2
Important
Safety Instructions . . . . . . . . . . . . . . 3
Subwoofer Placement
and Connection (Pictorial) . . . . . . . . 4
Your New Subwoofer . . . . . . . . . . . . 5
Power Requirements. . . . . . . . . . . . . 5
Room Acoustics . . . . . . . . . . . . . . . . 5
Wireless Operation . . . . . . . . . . . . . . 5
Subwoofer Placement. . . . . . . . . . . . 6
Subwoofer Connection . . . . . . . . . . . 7
Fine Tuning . . . . . . . . . . . . . . . . . . . . . 9
Technical Specifications . . . . . . . . . 10
Limited Warranty . . . . . . . . . . . . . . . 11