Paradigm Millenia LP - Manuel (Page 10)

8
Pull cables through or along wall and connect following the instructions on the next page.
Align keyhole slots (see inset) on rear of speaker with protruding screw heads on the bracket, then using
an “in and down” motion mount speaker on bracket.
Remove the two flathead screws (not shown). Drill inner pilot holes then
press anchor bolts firmly into drywall and screw in. Now insert all four
flathead screws and tighten.
WARNING! All screws must
be inserted straight and fully
tightened to ensure correct
operation of anchor bolts.
Step 3
Safety strap
attaches here
WIRING
Step 4
Step 5
Step 6
The Paradigm Reference logo is
magnetic and can be applied in a
horizontal or vertical configuration.