Paradigm Millenia 30 - Manuel (Page 6)

Fig. 9d (Before wiring speakers see note on Fig. 9d – 1 and Fig. 9d – 2 below)
CONNECTING SPEAKER
Pull cables through center hole in bracket and connect speaker following the
information on Page 10.
ADJUSTING THE SPEAKER’S ANGLE OF TILT
The self-adhesive bumper pads
(included) allow you to adjust the angle at which
your speakers sits on the wall:
• To further optimize imaging, you can tilt Left and Right speakers inward 7°
(Fig. 9d – 1) positioning the self-adhesive bumper pads marked 7° (as shown).
• To further optimize clarity and intelligibility, you can tilt the center speaker up
7° or down 7° (Fig. 9d – 2) positioning the bumper pads marked 7° (as shown).
• You can also mount the speakers parallel to the wall (Fig. 9d – 3) positioning
the self-adhesive bumper pads marked 0° (as shown).
Adjustments should be done before mounting speakers to the wall:
6
Horizontal Position
LEFT SPEAKER RIGHT SPEAKER
Rotate speaker
before wiring!
Adjusting Tilt on Left / Right Speakers
Fig. 9d – 3
To mount all speakers parallel to wall, attach pads
marked 0°
(as shown).
ALL SPEAKERS
Mounting Speakers Parallel to Wall
Fig. 9d – 1
The above image shows top view looking toward
listening area. Pads must sit at edges closest to
on-wall display.
LEFT SPEAKER: To tilt speaker inward, rotate
speaker 180° then attach the pads marked 7°
(as shown).
RIGHT SPEAKER: To tilt speaker inward, simply
attach the pads marked 7°
(as shown).
CENTER SPEAKER
Tilted down
Tilted up.
Rotate speaker
before wiring!
Adjusting Tilt on Center Speaker
Fig. 9d – 2
CENTER SPEAKER: (shown in side view) To tilt
speaker down, attach pads marked 7°
(as shown).
To tilt speaker up, rotate speaker 180° then attach
pads marked 7°
(as shown).
POSITIONING BUMPER PADS
Perspective in images shows only one pad. Two
pads are required, positioned as shown on the
lower recessed areas
(shaded areas) of the keyhole
slot sections (see Inset below).
Fig. 9e
Align keyhole slots (shown at right) on rear of speaker with pro-
truding screw heads on bracket, then using an “in-and-down”
motion mount speaker on bracket.
Horizontal Position
keyhole slots