Paradigm Titan Monitor v6 - Manuel (Page 9)

9
Start with just the front speakers and listen to familiar music in stereo.
The soundstage will be both wide and deep, but this can be tuned to your
personal preference by adjusting the toe-in (the amount the speakers are
turned toward the listening area). More toe-in will increase image depth
and localization, less toe-in will increase image width. Adjust the toe-in in
small increments, listening each time, until you achieve the soundstage
balance you prefer. Toe-in is not applicable to the other speakers in your
system since their position and sound distribution pattern is fixed. Fine tuning for center speakers is a matter of making volume level adjust-
ments that may be required for a particular multi-channel music or movie
program. If necessary, adjust your Audio/Video Processor’s or A/V Receiver’s
volume levels to ensure there is a cohesive overall soundstage.
To fine tune your surround/rear speakers or the subwoofer, refer to the
Owners Manual included with those speakers.
Paradigm ® speakers covered in this manual are warranted to be and
remain free of manufacturing and/or material defects for a period of five (5)
years from the date of original purchase. Within the time period specified,
repair, replacement or adjustment of parts for manufacturing and/or material
defects will be free of charge to the original owner.
Thermal or mechanical abuse/misuse is not covered under warranty.
Limitations:
• Warranty begins on date of original retail purchase from an Authorized
Paradigm ® Dealer only. It is not transferable;
• Warranty applies to product in normal home use only. If product is
subjected to any of the conditions outlined in the next section, warranty
is void;
• Warranty does not apply if the product is used in professional or
commercial applications.
Warranty is Void if:
• The product has been abused (intentionally or accidentally);
• The product has been used in conjunction with unsuitable or faulty
equipment;
• The product has been subjected to damaging signals, derangement in
transport, mechanical damage or any abnormal conditions;
• The product (including cabinet) has been tampered with or damaged by
an unauthorized service facility;
• The serial number has been removed or defaced.
Owner Responsibilities:
• Provide normal/reasonable operating care and maintenance;
• Provide or pay for transportation charges for product to service facility;
• Provide proof of purchase (your sales receipt given at time of purchase
from your Authorized Paradigm ® Dealer must be retained for proof-of-
purchase date).
Should servicing be required, contact your nearest Authorized Paradigm ®
Dealer, Paradigm Electronics Inc. or Import Distributor (outside the U.S. and
Canada) to arrange, bring in or ship prepaid, any defective unit. Visit our
website, www.paradigm.com for more information.
Paradigm Electronics Inc. reserves the right to improve the design of any
product without assuming any obligation to modify any product previously
manufactured.
This warranty is in lieu of all other warranties expressed or implied, of
merchantability, fitness for any particular purpose and may not be extended
or enlarged by anyone. In no event shall Paradigm Electronics Inc., their
agents or representatives be responsible for any incidental or consequential
damages. Some jurisdictions do not allow limitation of incidental or
consequential damages, so this exclusion may not apply to you.
Retain this manual and your sales receipt for proof of warranty
term and proof of purchase.
LIMITED WARRANTY
SOLUTION PROBLEM
TROUBLESHOOTING GUIDE
No Sound from One
or More Speakers
No Sound
Lack of Bass or
Dislocated Image
Make sure receiver, preamp or amplifier is plugged in and turned on. Check power outlet at the wall is working. Are headphones
plugged in, or is system on Mute? Re-check all connections.
Check your balance control or VC-150 Volume Control (if using). Check that all power cords are properly plugged in and
functioning. Swap a non-working speaker with one that works to determine if the problem is with the speaker or something
else (i.e. wiring, amplifier).
FINE TUNING (continued)
One or more speakers may be connected out of phase (their polarity is reversed). Re-check to ensure that each speaker’s cable
is connected with correct polarity: red (+) to red (+) and black (-) to black (-).